Real Throughput inspecting Wing Fasteners

Last week a major aircraft manufacturer put the fastCheck through its paces, testing a wide variety of aerospace fasteners from many manufacturers. It excelled itself, with excellent results on R&R checks which we hope to be able to share in the future. The performance and repeatability of the system caused a lot of excitement…

  • Multiple operators were trained to inspect fasteners for the R&R trials – each training session lasted around 5 minutes.  This thing is not hard to use – it is intuitive, as good tools should be…
  • These were not metrology specialists – they were a range of manufacturing apprentices, production operators and team leaders.
  • Following this training, there was almost no operator dependency.
  • Working on a wing, one operator inspected 1600 fasteners in 25 minutes.  This was 100% inspection of fasteners on a bottom wing skin – something which would be very challenging to achieve with a mechanical gauge.

If you are still using dial gauges to inspect aerospace fasteners, you really need to book a demonstration of this unit!